Dirt Bike Throttle Cable Sticking

But within 2 7 seconds ish of riding it i could tell that the throttle needed some attention. A sticky throttle could be caused by worn cables lack of lubrication in the cables or the cable getting bound up somewhere in the mechanism. If you are suspecting problems with a dirt bikes throttle body operation it s recommended that you check to be sure the throttle cables are not binding or crossed anywhere and causing a slow return of the throttle when released as short of this there is not much else that could cause a binding or sticking throttle as far as the throttle body.

diy rolling library ladder kit diamond cross hoop earrings design furniture online app diy stone look countertops design your own wedding dress online dielectric union installation on water heater dicor rv roof repair diamond pendant necklace ideas

How To Fix A Sticky Throttle On A Dirt Bike Cheap Easy

Dirt Bike Throttle Stuck Wide Open Motosport

How To Fix Dirt Bike Throttle Problems Motosport

Why Does My Motorcycle Throttle Stick Pack Up And Ride

Stuck Throttle Now What Motosport

How To Fix A Stuck Throttle On A Dirt Bike Partzilla Com

Although it would eventually.

Dirt bike throttle cable sticking.

Little else terrifies a rider on a dirt bike when that pin gets stuck. It had a definite and annoying stick at the start. The cables can bind under the tank or in the handgrip. Additionally the throttle cable just through general wear and tear stretches breaks or thanks to the dirt build up gets sticky too.

Next ride the throttle kept sticking open when i was riding so i decided to replace the throttle cable since it was getting a little frayed. Lube the throttle cable regularly which prevents it from getting. Not only was the dirt bike throttle sticking it was not snapping back and it seemed like the throttle wouldn t return. A few weeks ago i dropped my bike in a creek and sucked in quite a bit of water.

Inspect the throttle cable that it s routed properly and doesn t get pinched by the handlebars turning motion and not intertwined with the brake or clutch cables and electric start cable if applicable. Bike is a ktm 2 stroke. If the screws in the throttle housing are too tight it could cause the cable to stick. A stretched throttle cable won t give your bike much life and obviously a broken cable doesn t work but a sticky cable or throttle tube can produce these kinds of results.

Or it can be caused by an issue with the carburetor or efi. Pretty darn cool bike actually. Drained it out and bike was good to go.